SwingSafe Installation Instructions          

1. Wrap SwingSafe around the swing leg. Make sure the large fill valve is on the top and the small drain valve is on the bottom. 
2. Position the top two eyelets above the crossbar. Tie the top two eyelets together with a square knot (use long cord).  See Figure 1
3. Thread the middle eyelets and tie a square knot.  Repeat this process for the bottom eyelets (Use short chords).  See Figure 2
4. Close the bottom drain valve tightly.
5. Using a garden hose, slowly fill from top valve until all SwingSafe chambers are full.  Allow excess air to vent out.  It is normal for water to squirt from the large valve while filling.
6. Close large valve tightly.
7. Repeat this process for each SwingSafe.

                              Figure 1                                                                   Figure 2

                                                                        Back to the SwingSafe Water-Filled Swing Safety System page

                                                                                            Patent No. 6,375,145

                                Figure 3